EMCS User Guide
- 14 -
Cmd #
Command
Range
Default
23 Ring Phone Extension 0 = OFF (incoming will not ring remote)
1 = ON (remote phone rings on incoming
call – required for CID alarm display)
0
24 Caller ID Update Timer 1-30 minutes (alarm reporting frequency)
1
25 Start PLM Test 1 = CONFIRM N/A
26 PLM Check Interval 0 = 12 hours
1 = 5 hours
0
30 Handset Volume Setting 0 = soft, 9 = loud 5
31 Handset Mic. Sensitivity 0 = least sensitive; 9 = most sensitive 5
32 TEL1 Line boost 0 = min; 9 = max boost 2
33 TEL 2 Line boost 0 = min; 9 = max boost 2
34 Rem. Phone attenuation 0 = min.; 8 = max attenuation 4
43 Factory Reset 1 = CONFIRM N/A
44 Remote Silence Buzzer 1 = CONFIRM N/A
45 PIM Firmware Version Replay only Pre-set
46 CSM Firmware Version Replay only Pre-set
47 CSM Hardware Version Replay only Pre-set
50 PLM Group 0 (OFF) 1-6 (or 1-12 with EMCS-EXP) -
51 PLM Group 1 1-6 (or 1-12 with EMCS-EXP) default All cabs
52 PLM Group 2 1-6 (or 1-12 with EMCS-EXP) -
53 PLM Group 3 1-6 (or 1-12 with EMCS-EXP) -
54 PLM Group 4 (only with EMCS-EXP) 1-12 -
55 PLM Group 5 (only with EMCS-EXP) 1-12 -
56 PLM Group 6 (only with EMCS-EXP) 1-12 -
60 EMCS ID 0-9 (set > 0 if more than one EMCS) 0
To Next Page
Loading...
