EMCS User Guide
- 20 -
6.2.22
Commands # 50 to # 56: PLM GROUP ASSIGNMENT (EMC-MR)
Command #50 allocates the cab specified (1-12) to group 0 (no alarm).
Command #51 allocates the cab specified (1-12) to group 1 (default).
Command #52 allocates the cab specified (1-12) to group 2.
Command #53 allocates the cab specified (1-12) to group 3.
Command #54 allocates the cab specified (1-12) to group 4.
Command #55 allocates the cab specified (1-12) to group 5.
Command #56 allocates the cab specified (1-12) to group 6.
Examples: To allocate cab #4 to PLM group #2, in programming mode,
touch 52 <ENTER> 4 <ENTER>.
Touch 52 <REPLAY> to list all cabs assigned to group 2.
All cabs are assigned to Group #1 by default and need to be pulled to their new Group.
Cabs assigned to Group #0 are ignored by the daily PLM check.
Voice Prompt: “PLM Group”
6.2.23
Command # 60: EMCS ID
A unique ID must be assigned to each Consolidator if more than one are connected in
the system. Use default ID = 0 for systems with only one Consolidator.
Voice Prompt: “EMCS ID”
To Next Page
Loading...
