EmerCom Technologies EMCS-OEM - Command # 2: OPERATING MODE; Command # 3: PHONE LINES AVAILABLE; Command # 4: ACTIVE STATIONS; Command # 5: INACTIVE STATIONS

EMCS User Guide
- 16 -
6.2.2
Command # 2: OPERATING MODE
The Consolidator routes conversations according to site requirements. In “Lobby mode”,
emergency calls from the cabs are directed to all in-building “authorized personnel”
handset locations. “TEL mode” directs calls off-site via the wired phone line(s). In
“Intelli-split mode”, emergency calls are directed to either in-building or off-site
“authorized personnel” locations, depending on line availability.
Voice Prompt: “Operating mode”
6.2.3
Command # 3: PHONE LINES AVAILABLE
This sets the number of valid phone lines wired to the system. The “Learn mode” auto-
configuration setting can be overridden manually.
Voice Prompt: “Phone lines available”
6.2.4
Command # 4: ACTIVE STATIONS
The station numbers of active cabs are assigned using this command. Input each
station number to be activated followed by <ENTER> or touch <REPLAY> to hear a list
of all cabs currently assigned. The “Learn mode” auto-configuration setting can be
overridden manually.
Voice Prompt: “Active stations”
6.2.5
Command # 5: INACTIVE STATIONS
Use this command to unassign cabs by inputting the station number followed by
<ENTER> or touch <REPLAY> to hear a list of inactive cabs. The “Learn mode” auto-
configuration setting can be overridden manually.
Voice Prompt: “Inactive stations”
6.2.6
Command # 6: SERIAL NUMBER PLAYBACK
Factory set. Use the serial number playback command to report the serial number (as
displayed on the sticker attached to the main circuit board).
Voice Prompt: “Serial number”
6.2.7
Command # 7: MAIN FIRMWARE VERSION PLAYBACK
Replays the Consolidator’s main circuit board firmware version.
Voice Prompt: “Firmware version”