EMCS User Guide
- 21 -
6.3 Remote Programming
Lift the EMC-MR/Remote Phone handset. If an internal emergency call or an internal
ALL CALL or an internal non-emergency call is already in-progress, the EMC-MR will
join the call; otherwise the Consolidator will answer with one of the following prompts:
“Station number #x is in conversation”
“No available phone lines”
“Phone line number #y is unavailable”
“Off-site ALL CALL in-progress” or
“Select the station number you wish to speak to followed by the star (*) key, or
select star-star (**) for further options”
- Select star-star (**)
“Select nine-star (9*) to call off-site, zero-star (0*) to call the lobby,
select star-star (**) to initiate an all system page or enter the
access code for programming mode” (factory default is 12345)
- Enter the access code, to which the Consolidator will respond “Program”
followed by a confirmation beep unless the access code is incorrect, in
which case the prompt “Incorrect entry, please re-enter” will play.
In remote programming, key sequences exist to replicate the functions found on the
Consolidator keypad. Use the following table to look-up the equivalent remote key
sequence for the different keypad functions:
Keypad Equivalent Remote Sequence
PROGRAM 99* + “Access Code”
CANCEL *1
ENTER **
REPLAY #
EXIT *9
To Next Page
Loading...
