2. Navigate to System Settings → Gateway → Ethernet Communication to enter the
network settings.
a)
Configure a static IP Address or set for DHCP and enter a Hostname.
b) If not prompted, restart application at System Settings → Gateway →
Backup and Restore → Restart Apps.
Note
Resetting applications will temporarily disable communications with field devices.
2.3.6 User accounts
There are four role-based user accounts for the Gateway with varying levels of access. The
access can be changed on the System Settings → Users → User Accounts by the admin
user. The figure below displays this access.
Reference Manual Configuration
00809-0600-4410 May 2020
Emerson 1410S/781S 15
To Next Page
Loading...
