4 Physical installation
4.1 Emerson 1410S mounting
Find a location where the gateway has convenient access to the host system
network (process control network).
4.1.1 1401S1 DIN-rail mounting
The Emerson Wireless 1410S1 Gateway can be snapped onto a DIN TS35/7.5
or TS35/15 rail system. To clip the gateway onto the DIN rail, see Figure 4-1.
Prerequisites
• DIN-rail for mounting gateway
• Emerson Wireless 1410S1 Gateway
Procedure
1. Press down on the upper release tab of the gateway to release the
mounting clip.
2. Align top teeth on top of DIN-rail and rotate bottom teeth into
bottom of DIN-rail.
3. Release upper tab to secure the gateway to the DIN-rail.
4. To remove, press down on upper tab to release the gateway from the
DIN-rail.
NOTICE
When mounting the unit in an electrical enclosure or other location,
comply with the appropriate local and national installation codes.
Verify that the installer, associated hardware, and installation
equipment used have the proper certifications for the specific type of
installation being performed. Before installation, verify if local codes
require a permit and/or an inspection before energizing. When
planning the installation, account for routing the antenna cable
within the enclosure.
Note
Do not mount the antenna within a metal enclosure. To avoid
damage to sensitive RF components, do not remove protective cap
from the gateway SMA connector until ready to install the antenna.
Quick Start Guide July 2022
18 Emerson.com
To Next Page
Loading...
