4.1.2 1410S2 Pipe mount
Prerequisites
The following hardware and tools are needed to mount the gateway to a 20-
in. pipe:
• Two 5/16-in. u-bolts kits (supplied with gateway)
• 2-in. mounting pipe
• 1/2-in. wrench
Procedure
1. Insert one u-bolt around the pipe, through the top mounting holes of
the gateway mounting plate, and through the washer plate.
2. Use a 1/2-in. wrench to fasten the nuts to the u-bolt.
3. Repeat for the second u-bolt and the lower mounting holes.
Figure 4-2: Emerson 1410S2 Mounting
4.1.3 1410S2 Surface mount
The following hardware and tools are needed to surface mount the gateway
to a support bracket:
Prerequisites
• Four appropriate fasteners for preferred mounting method
• Mounting plate (supplied with gateway)
• Drill (not supplied)
• Wrench (not supplied)
Quick Start Guide July 2022
20 Emerson.com
To Next Page
Loading...
