Emerson 375 - Change and Send Parameter Data

Fieldbus Functionality
4-15
Modified Parameters
An asterisk (*) will appear next to a modified parameter
that has not yet been sent to the device.
Display Parameters
To display the parameters for fieldbus devices:
1. Display the Live Device List; see page 4-9.
2. Double-tap a device.
3. Double-tap the desired block, or the appropriate item
from a device menu.
4. Double-tap the desired parameter group. The
parameters and their current values are displayed.
Shaded areas indicate values that cannot be edited.
Change and Send Parameter Data
To change the values for parameters:
1. Display the parameters for the device.
2. Double-tap the desired parameter.
3. Change the value for the parameter.
(Tap HELP to view a description of the parameter.)
4. Tap OK to acknowledge the parameter change.
Repeat these steps for other parameters as
necessary. A “*” symbol indicates a parameter has
been edited.
5. Tap SEND to commit your changes to the connected
device.
Display Device Status
To display device status:
1. Display the Live Device List; see page 4-9.
2. Double-tap a device.
3. Double-tap the desired block.
4. Double-tap Status. Status parameters are displayed.