Emerson 375 - Run Fieldbus Device Methods

Fieldbus Functionality
4-16
Run Methods
Select submenu choices as appropriate. Different
devices have different methods associated with them,
and the selections on these menus vary accordingly.
To run methods:
1. Display the Live Device List; see page 4-9.
2. Double-tap a device.
3. Double-tap the desired block (typically, methods are
run in the transducer block).
4. Double-tap Methods.
5. Double-tap the type of method you want to run, for
example, calibration, diagnostic, or sensor trim.
Follow the navigation screens to run the method.
Display the Details menu
To view the device details:
1. Display the Live Device List; see page 4-9.
2. Double-tap a device.
3. Double-tap Advanced.
4. Double-tap Detail. Double-tap one of the following
options:
NOTE
The physical device tag and address of a device will be
read-only when, at a minimum, any of the following
hosts/linking devices are detected on the segment:
Rosemount 3420, DeltaV, Ovation, Allen-Bradley,
Honeywell Experion PKS, or Yokogawa Stardom. To
change the device tag or address, use the host system
or remove the device from the segment and connect it
directly to the 375 Field Communicator.