Emerson AMS 2140 - Page 29

Horizontal machine moveFigure 4-5:
For horizontal machine moves, if the required movement is positive, the
amount of movement is shown below the machine at the appropriate
foot with a down arrow. If the required movement is negative, the
amount of movement is shown above the machine at the appropriate
foot with an up arrow.
The bottom half of the AMS 2140 screen shows a bull’s-eye target and a
shaft centerline plot representing the alignment condition of the
machine. The shaft centerline plot includes a “V” shape indicating the
acceptable angular tolerance on the machine as well as a bracket at the
base of the “V” showing the acceptable offset misalignment at the
coupling.
The bull’s-eye target compares the total misalignment to the target
tolerance. Each circle in the bull’s-eye target has a different meaning:
red—more than two times the tolerance, yellow—between one and two
times the tolerance, green—within acceptable tolerance, green with a
star—within excellent tolerance.
Optionally, you can do the following:
a.
Press F4 Extra Foot to calculate the vertical and horizontal machine
moves for up to four machine foot locations in addition to those
defined for the job.
December 2018 Quick Start Guide
Quick Start Guide 29