Configuration
[48]
Figure 8-6: Select an EZ 1000 for online configuration
A.
Button
Configure
for opening the configuration editor.
B.
Selected EZ 1000 converter.
If the selected EZ 1000 is not configured, the New Configuration dialog opens (see
Section 8.2
). Otherwise, the configuration editor opens directly.
See
Section 8.5
for parameter description and settings.
2. Check the configuration, and modify it in accordance to the requirements.
8.4 Configuration of an already existing converter
1. Select the converter to be reconfigured from the Network list.
2. Click Configure to open the configuration editor.
3. Make the changes to the configuration.
4. Run the calibration process. The configuration is sent to the converter during this
process (see Section 8.5.5).
5. Click Close configuration to close the editor. Do not click Send & close.
8.5 Configuration editor and parameters
Figure 8-7
shows an overview about the configuration editor
Configuration
.
To Next Page
Loading...