Configuration
[55]
Figure 8-20: Input
Point Id Enter the point ID of the measuring point where the sensor is installed.
Sensor
Click the button behind the display field to open the selection dialog
for the sensor. The dialog lists all eddy current sensors compatible with
EZ 1000. Select the appropriate sensor, and click OK.
Serial number Enter the serial number of the used sensor. See sensor or sensor cable
for the serial number.
Extension
cable
If an extension cable is used, click the button behind the display field
to open the selection dialog for the extension cable. The dialog lists all
extension cables compatible with the EZ 1000 and the sensor already
selected. Select the appropriate extension cable or select No extension
cable, and click OK.
Serial number Enter the serial number of the used extension cable. See label of the
extension cable for the serial number.
Note
The sensor adapter EZ1900-003-ADAP-2 is automatically considered during the calibration process,
if Sensor > 3301x is selected.
8.5.4 Measurement
Enter the measurement details.
Figure 8-21: Measurement
To Next Page
Loading...