Emerson ControlWave Series User Manual

Emerson FB2200 Flow Computer Instruction Manual
D301784X012
March 2019
Installation 51
2.11 Installing the Optional 30W Solar Panel
If you purchased the lead acid battery/30W solar panel kit for main power, you need to install the
supplied solar panel. Refer to Figure 2-40 during this procedure.
DANGER
EXPLOSION HAZARD: Never remove end cap(s) in a hazardous location. Removing end cap(s) in a
hazardous location could result in an explosion.
Solar panel installation involves:
▪ Mounting the solar panel on a pole
▪ Wiring power to the solar panel. (See Section 2.10.3)
▪ Setting the tilt angle of the panel for maximum solar exposure. (See Section 2.13)
Install the solar panel as follows:
1. Attach the adjustable angle bracket (Item 2 in Figure 2-40) to the solar panel (Item 1) using
the hex screws (Item 5), flat washers (Item 6), lock washers (Item 7), and hex nuts (Item 8).
2. Torque hex nuts (Item 8) to 60 in-lbs (6.8 N m).
3. Apply Loctite® 222MS™ Purple Threadlocker Low Strength sparingly to hex nut threads
(Item 8) after torqueing.
4. Attach pole mounting bracket (Item 3) to angle bracket (Item 2) using hex screws (Item 12),
flat washers (Item11), lock washers (Item 10) and hex nuts (Item 9).
5. Torque hex nuts (Item 9) to 108 in-lbs (12.2 N m).
6. Apply Loctite 222MS Threadlocker sparingly to hex nut threads (Item 9) after torqueing.
7. Attach entire solar panel assembly to pole by attaching pole mounting bracket (Item 3) to U-
bolt assembly (Item 4). Torque nuts in U-bolt assembly to 60 in-lbs (6.8 N m).
8. Apply Loctite 222MS Threadlocker sparingly to hex nut threads (Item 8) after torqueing.
9. Attach a ground wire at the back of the solar panel. For more information on grounding,
refer to Site Considerations for Equipment Installation, Grounding, and Wiring Manual
(D301452X012).

Emerson ControlWave Series Specifications

General

Brand	Emerson
Model	ControlWave Series
Category	Desktop
Language	English