1592026260 IEV22-24D GB r.1.0 21.02.2019 IEV 46/60
Holding time of Et1 steps at the start-up of the
regulation in chiller mode
Interval of updating valve position in chiller
mode
Interval time for valve opening when a probe is
damaged in chiller mode
Valve opening percentage when a probe is
damaged in chiller mode
PID configuration in heat pump mode (valve 1 and valve 2)
PID proportional constant in heat pump mode
PID integral time in heat pump mode
PID derivative constant in heat pump mode
Overheating regulation set point during heat
pump mode
Overheating regulation dead band in heat
pump mode
High overheating threshold in heat pump
mode.
The alarm status is signaled after the high
overheating alarm activation delay
Low overheating threshold in heat pump mode.
The alarm status is signaled after the low
overheating alarm activation delay
Low overheating protection added integral time
in heat pump mode
MOP Protection activation threshold in heat
pump mode.
High evaporating temperature threshold. The
alarm status is signaled after the high
evaporating temperature alarm activation delay
Step Rate during MOP or LOP protection
(number of steps every second) in heat pump
mode
LOP Protection activation threshold in heat
pump mode.
Low evaporating temperature threshold. The
alarm status is signaled after the low
evaporating temperature alarm activation delay
Percentage decreasing in case of low
superheating condition in heat pump mode
Max. value of valve opening in heat pump
mode (percentage)
Min. value of valve opening in heat pump mode
(percentage)
Pressure measure Filter in heat pump mode
Temperature measure filter in heat pump mode