S600 Instruction Manual
Figure 2-6. Panel Cutout Dimensions
Note: The S600 fits into existing S500, 869 flow computer panel
cutouts.
3. Ensure a panel thickness of at least 3 mm (0.12 in) to prevent
distortion. If you use a thinner panel, support the rear of the case
(refer to Figure 2-7).
Caution
Always use a rear support or anchor to prevent twisting and other
distortion effects during installation and maintenance.
Figure 2-7. Panel Mount Support
2-6 Installation Revised Jan-07
To Next Page
Loading...
