Discharge Air Controller (DAC) Manual Software Overview • 27
3. Press % SETUP to access the iProDAC
Setup screen (Figure 7-8).
4. Press Ctrl + 0 and select F Sensor Offsets or
press
to access the C0: MORE tab
and scroll through the tabs to access the Sen-
sor Offsets (Figure 7-9).
5. Enter the appropriate offset value
(Figure 7-9).
Figure 7-7 - iProDAC Status Screen - Press F5
Figure 7-8 - iProDAC Setup Screen in E2 - Ctrl + 0 Tab
Menu Sensor Offsets
Figure 7-9 - Sensor Offset Properties in E2 - C0: MORE
Tab
To Next Page
Loading...
