Operation and Display Panel
25 Liebert
®
GXT4
™
3.4.1 Startup Screen
When the Liebert GXT4 is starting up, it initiates a self-test and displays the screen shown in
Figure 19 for about 10 seconds.
Figure 19 Startup screen
After about 10 seconds, the LCD shows one of the On screens in Figure 20; the screen shown depends
on whether input power is available.
Figure 20 Startup screens
To turn on the UPS, press either the Up or Down button to select YES and press the Enter button.
The UPS will start up, the LCD will display UPS STARTING and then START SUCCESSFUL after
the UPS is turned On, as shown in Figure 21.
Figure 21 Starting and Start Successful screens
O/P: 0V HZ 0.0A
I/P : 230 V 50HZ 0.0A
BATT: 100 % 320 MINS
LOAD: 0%
TURN ON UPS
YES NO
O/P: 0V 0HZ 0.0A
I/P : 230V 50HZ 0.0A
BATT: 100% 320MINS
LOAD: 0%
AC NOT AVAILABLE
START ON BATTERY?
YES NO
Input Power is Available
Input Power is Not Available
O/P: 0V 0HZ 0.0A
I/P : 230V 50HZ 0.0A
BATT: 100% 320MINS
LOAD: 0%
UPS STARTING
O/P: 230V 50HZ 4.6A
I/P : 230V 50HZ 5.0A
BATT: 100% 15MINS
LOAD: 40%
START SUCCESSFUL
To Next Page
Loading...
