2 Mounting and sensor wiring
2.1 Mounting and sensor wiring for integral-
mount transmitters
There are no separate mounting requirements for integral transmitters, and no need to
connect wiring between the transmitter and the sensor.
2.2 Mount the transmitter to a wall or instrument
pole
There are two options available for mounting the transmitter:
• Mount the transmitter to a wall or flat surface.
• Mount the transmitter to an instrument pole.
Prerequisites
• If you are mounting the transmitter to a wall or flat surface:
— Ensure that the surface is flat and rigid, does not vibrate, or move excessively.
— Confirm that you have the necessary tools, and the mounting kit shipped with the
transmitter.
• If you are mounting the transmitter to an instrument pole:
— Ensure that the instrument pole extends at least 12 in (305 mm) from a rigid base,
and is no more than 2 in (51 mm) in diameter.
— Confirm that you have the necessary tools, and the instrument-pole mounting kit
shipped with the transmitter.
Procedure
1. Attach the mounting bracket to the transmitter and tighten the screws.
Installation Manual Mounting and sensor wiring
MMI-20058013 April 2019
Installation Manual 11
To Next Page
Loading...
