Figure 3-6: Channel and wiring configurations label
3.6 Wire the Channel A mA HART output
To wire the mA/HART output in explosion-proof, intrinsically safe, or nonhazardous
installations, follow this procedure.
Important
Meter installation and wiring should be performed only by suitably-trained personnel
using the appropriate government and corporate safety standards.
Procedure
Wire to the appropriate output terminal and pins.
Figure 3-7: Channel A mA/HART output wiring (externally powered)
A. mA HART output
B. Supply Voltage (See Figure 3-1.)
C. Loop Resistance (See Figure 3-1 for maximum loop resistance.)
D. Input device
Installation Manual Wiring the channels
MMI-20058013 April 2019
Installation Manual 29
To Next Page
Loading...
