Figure 2-10: Rotation of the sensor wiring junction box
3. Gently set the junction box into its new position, confirming that the position is
locked.
4. Replace the clamp in its original position and tighten the cap screw. Tighten the
screw to 28 in lbf (3.16 N m)– 32 in lbf (3.62 N m).
Figure 2-11: Re-attachment of the clamp
Mounting and sensor wiring Installation Manual
April 2019 MMI-20058013
20 Micro Motion
®
4200 2-Wire Transmitter
To Next Page
Loading...
