1 Planning
1.1 About this document
This manual provides information on planning, mounting, wiring, and initial setup
of the Micro Motion transmitter. For information on full configuration, maintenance,
troubleshooting, or service of the transmitter, see the appropriate configuration and use
manual.
The information in this document assumes that users understand basic transmitter and
sensor installation, configuration, and maintenance concepts and procedures.
1.2 Related documentation
See the approval documentation shipped with the transmitter, or download the
appropriate documentation from the Micro Motion web site ( www.emerson.com/
flowmeasurement):
• Micro Motion 4700 Configurable Inputs and Outputs Transmitter; Configuration and Use
Manual
• Micro Motion 4700 Configurable Inputs and Outputs Transmitter; Product Data Sheet
• Micro Motion ProLink III with ProcessViz Software User Manual
• Coriolis Flow Meter with Micro Motion 4700 Configurable Inputs and Outputs Transmitter:
Safety Manual for Safety Instrumented Systems (SIS)
• Sensor installation manual, shipped with the sensor
• FMEDA report for Coriolis Flow Meter with 4700 Transmitter, prepared for Emerson by
exida.com LLC
1.3 Meter components
A meter consists of the following components:
• A transmitter
• A sensor
1.4 Installation types
The 4700 transmitter was ordered and shipped for one of three installation types. The fifth
character of the transmitter number indicates the installation type.
Figure 1-1: Installation type indication for 4700 transmitters
The number is located on the device tag on the side of the transmitter.
Installation Manual Planning
00825-0100-5710 October2023
Installation Manual 5
To Next Page
Loading...
