Emerson Powerdrive F300 - Page 13

Powerdrive F300 Getting Started Guide 13
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
Input line reactor (Frame 9E, 10E and 11E)
A line reactor must be used with Frame 9E, 10E and 11E. Failure to provide sufficient reactance could
damage or reduce the service life of the drive. Refer to Table 2-8.
Table 2-8 Size 9E, 10E and 11E Model and Line reactor part number
* Natural cooling.
** May represent a more economic solution where operating temperature and cooling requirements
are observed.
*** May represent a more economic solution when operating below 420 A.
Size Drive model Inductor model
Line reactor part
number
9E
09202160, 09202660, 09402210, 09402660
INL 401 4401-0181
INL 401W** 4401-0208
09501250, 09501500, 09601720, 09601970 INL 601 4401-0183
10E
10203250, 10203600, 10403200, 10403610
INL 402 4401-0182
INL 402W** 4401-0209
10502000, 10601720, 10601970 INL 602 4401-0184
11E
11404370 INL 403L*** 4401-0274
11404370, 11404870, 11405070 INL 403* 4401-0259
11502480, 11502880, 11503150, 11602250,
11602750, 11603050
INL 603* 4401-0261
Powerdrive F300 Getting Started Guide English Iss2.book Page 13 Tuesday, July 28, 2015 3:23 PM