Powerdrive F300 Getting Started Guide 29
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
Figure 3-11 Removal of the size 5 internal EMC filter
Remove the three M5 terminal nuts (1). Lift away the cover (2) to expose the M4 Torx internal EMC
filter removal screw. Finally remove the M4 Torx internal EMC filter removal screw (3) to electrically
disconnect the internal EMC filter.
Figure 3-12 Removal of the size 6 internal EMC filter
To electrically disconnect the Internal EMC filter, remove the screw (1) as highlighted above.
Powerdrive F300 Getting Started Guide English Iss2.book Page 29 Tuesday, July 28, 2015 3:23 PM
To Next Page
Loading...
