Powerdrive F300 Getting Started Guide 81
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
7.3.2 Select the discovered drive
1. Select the ‘Online’ icon to connect with the drive. When a successful connection is made the icon will
be highlighted orange.
2. Select ‘Set mode and region’.
If the required control mode is highlighted in the ‘Drive Settings’ dialog, then:
• Change the supply frequency, if required and select ‘Apply’, otherwise select ‘Cancel’.
• Select ‘Default parameters‘ from the Dashboard and in the ‘Default Parameters’ dialogue,
select ‘Apply’
If the required control mode is not highlighted in the ‘Drive Settings’ dialog then:
• Select the required mode and supply frequency.
• Select ‘Apply’.
3. Select ‘Set-up’ and perform the steps highlighted (dotted lines indicate a step which may not need to be
performed (see below):
4. Select 'Save parameters in drive' to perform a parameter save. The drive is now ready to run.
Action Detail
Motor Set-up
Powerdrive Connect contains a database for induction motors and permanent magnet
motors. Provision is also made to enter motor nameplate data.
The next section describes the use of the motor database for a Leroy Somer LSRPM motor
used in RFC-S Sensorless mode.
Analog I/O
The motor thermistor can be selected in Pr 07.011. Refer to the parameter help for
Pr 07.011 for further information.
Ramps Set-up Enter the required Acceleration rate and Deceleration rate
Autotune
Not required when using data from the motor database for a Leroy Somer LSRPM motor
used in RFC-S Sensorless mode.
Powerdrive F300 Getting Started Guide English Iss2.book Page 81 Tuesday, July 28, 2015 3:23 PM
To Next Page
Loading...
