34
Safety Manual
00809-0200-5100, Rev GB
Installation and Configuration
February 2017
Installation and Configuration
Step 1 Device verification
1. In the Device Information pane check that the Device Id is identical to the Device Id on
the main label attached to the 5900 housing. For a 5900 2-in-1 version, the Device Id is
divided in two parts. The first part is for the Primary device and the second for the
Secondary device as described in
Appendix C: Safety System Identification.
2. In the Device Information pane check the Device Id Checksum.
Device Id Checksum = Device Id+ SIL Manipulated Device Id.
The Device Id Checksum must be equal to x9999 (in case of five digit Device Id), where
x is equal to the figure in the corresponding position of the Device Id.
Example: Device Id=10010. SIL Manipulated Device Id=9989.
Device Id Checksum=10010+9989=19999.
3. Verify that Device Type=5900 RLG and Device Type No.=23.
4. Make a note of the SIL Write Config Counter. This figure is used for verifying that the
5900 properly reads and writes safety alarm parameters.
5. In the Device Information pane verify that the correct SIL Software version is used, see
Appendix C: Safety System Identification.
To Next Page
Loading...
