49
Safety Manual
00809-0200-5100, Rev GB
Installation and Configuration
February 2017
Installation and Configuration
4.2.11 How to enable SIL Low Alarm Limit
To enable the SIL Low Alarm Limit function:
1. In the Safety Alarm window, click the Change Parameters button to open the Change
Safety Alarm Parameters window.
2. In the “Surface Track Control” field, type the desired SIL Low Alarm Limit value and
click the Apply button.
3. Check that the “Surface Track Control” field is changed to SIL Low Alarm Limit.
SIL Surface Track Control
To Next Page
Loading...
