16
Safety Manual
00809-0200-5100, Rev GB
Installation and Configuration
February 2017
Installation and Configuration
4.1.4 Rosemount 2410 relay output connection
The Rosemount 2410 SIL relay output is connected to the Exd/Exe terminal block as illustrated
below.
Figure 4-4. 2410 non-IS terminal block
Table 4-4. Terminal assignment for 2410 non-IS terminal block
Terminal Designation Function
1 N / - Power, Neutral / DC -
2 L / + Power, Line / DC +
3 K1 A Relay 1 output (optional). Hardware configurable
NO/NC.
4 K1 com Relay 1 common
5 K2 A Relay 2 output (optional). Hardware configurable
NO/NC.
6 K2 com Relay 2 common
7a/7b P Bus B Primary communication bus
8a/8b P Bus A
9 Not used
10 Not used
11 Alarm B SIL Alarm Relay (terminal B)
12 Alarm A SIL Alarm Relay (terminal A)
PE PE Protective power supply ground
GND_1 GND_1 Housing chassis/shield Primary bus
GND_2 GND_2 Housing chassis/shield Secondary bus
Ground screws
Ground screw
SIL Alarm Relay Output
Non-IS (Exd/Exe) compartment
To Next Page
Loading...
