7. Verify the Reference/Atmospheric Conditions are correct for the
application. These values may be edited as needed.
Note
Reference pressure and temperature values are used by
Engineering Assistant to convert the flow rate from mass units
to mass units expressed as standard or normal volumetric
units.
8. Select Next to proceed to the Fluid Properties tab.
7.5 Fluid properties
Note
The Fluid Properties tab is an optional step and is not required to
complete a flow configuration.
The Fluid Properties tab for the database gas air is shown in Figure
7-5. This is used to verify the properties of the chosen fluid are
acceptable.
To check density, compressibility, and viscosity of the selected fluid
at other pressure and temperature values, enter a Pressure and
Temperature and select Calculate.
Note
Changing the pressure and temperature values on the Fluid
Properties tab does not affect the fluid configuration.
January2024 Quick Start Guide
Quick Start Guide 27
To Next Page
Loading...
