Emerson Rosemount 3051S Series - Engineering Assistant installation; System requirements; Install Rosemount 3051 SMV Engineering Assistant

6 Engineering Assistant installation
Engineering Assistant 6.1 or later
The Rosemount 3051SMV Engineering Assistant 6.1 or later is PC-
based software that performs configuration, maintenance, diagnostic
functions, and serves as the primary communication interface to the
transmitter with the fully compensated mass and energy flow feature
board.
The Rosemount 3051SMV Engineering Assistant software is required
to complete the flow configuration.
NOTICE
To ensure correct operation, download the most current version of
the Engineering Assistant software at Emerson.com/Rosemount-
Engineering-Assistant.
6.1 System requirements
The following are the minimum system requirements to install the
Rosemount 3051SMV Engineering Assistant software:
• Pentium
®
-grade processor: 500 MHz or faster
• Operating system: Windows
™
XP Professional (32-bit), or Windows
7 (32-bit or 64-bit)
• 256 MB RAM
• 100 MB free hard disk space
• RS232 serial port or USB port (for use with HART
®
modem)
• CD-ROM
6.2
Install Rosemount 3051SMV Engineering Assistant
6.1 or later
Procedure
1. Uninstall any existing versions of Engineering Assistant 6.
2. Insert the new Engineering Assistant disk into the CD-ROM.
3. Windows should detect the presence of a CD and start the
installation program. Follow the on-screen prompts to finish
the installation. If Windows does not detect the CD, use
Windows Explorer or My Computer to view the contents of the
CD-ROM, and then double click the SETUP.EXE program.
January2024 Quick Start Guide
Quick Start Guide 19