Emerson Rosemount 3051S Series - Connect to a personal computer

4. A series of screens (Installation Wizard) will appear and assist
in the installation process. Follow the on-screen prompts. It is
recommended to use the default installation settings.
Note
Engineering Assistant versions 6.1 or later require the use
of Microsoft
®
.NET Framework version 4.0 or later. If .NET
version 4.0 is not currently installed, the software will
be automatically installed during the Engineering Assistant
installation. Microsoft .NET version 4.0 requires an additional
200 MB of disk space.
6.3 Connect to a personal computer
Procedure
1. Remove the cover from the field terminals side of the housing.
2. Power the device as outlined in Connect wiring and power up.
3. Connect the HART modem cable to the PC.
4. On the side of the transmitter marked “Field Terminals,”
connect the modem mini-grabbers to the two terminals
marked “PWR/COMM.”
5. Launch the Engineering Assistant software. For more
information on launching software, see Launch Engineering
Assistant 6.1 or later.
6. Once the configuration is complete, replace cover and
tighten until metal contacts metal to meet explosion-proof
requirements.
Figure 6-1 shows how to connect a computer to a Rosemount
3051SMV.
Quick Start Guide January2024
20 Emerson.com/Rosemount