Screen component Description of use
D The Next button is used to step forward through
the flow configuration tabs. In Offline mode,
the Next button will not become active until
all required fields on the current page are
completed.
E The Help button can be clicked at any time to get
a detailed explanation of the information that is
required on the current configuration tab.
F Any configuration information that needs to be
entered or reviewed will appear in this portion of
the screen.
G These menus navigate to the Configure Flow,
Basic Setup, Device, Variables, Calibration, and
Save/Send Configuration tabs.
H These buttons navigate to Config/Setup, Device
Diagnostics or Process Variables sections.
7.2 Launch Engineering Assistant 6.1 or later
Flow configuration for the Rosemount 3051SMV is achieved by
launching the Engineering Assistant software from the Start menu.
Procedure
1. Select the Start menu → All Programs → Engineering
Assistant. Engineering Assistant will open to the screen shown
in Figure 7-2.
2. Select Offline button located in the lower right hand corner of
the screen shown in Figure 7-2.
Quick Start Guide January2024
24 Emerson.com/Rosemount
To Next Page
Loading...
