Emerson Rosemount 3152 - Page 5

Reference Manual
00809-0100-4835 Rev BE
February 2018
Rosemount 3150 Series
Title Page
v
Revision Status
Changes from July 2016 (Rev BD) to February 2018 (Rev BE)
Page
(Rev BD)
Page
(Rev BE)
Changes
Cover,
throughout
Cover,
throughout
Document revision change from July 2016 to February 2018, Rev BD to Rev BE;
Updated document formatting, page numbers, spelling, grammar, and references for
consistency and accuracy; Remove unnecessary references to Rosemount Nuclear
Instruments, Inc. and abbreviate to Rosemount Nuclear; Revised Swagelok
TM
to
Swagelok
®
.
2-2 8
Moved NOTE regarding flushing lines for steam service from Mechanical
Considerations section to Mounting Configuration section.
2-3 5
Removed NOTE regarding transmitter venting and draining and referred to Figure 2-
2 in Impulse Piping section; Added 1/4 inch Swagelok
®
to Process Connections and
Interfaces section.
2-4 6
Added headers Assembly and Re-assembly to Process Connections and Interfaces
section; Reworded Re-assembly instructions to provide clarity.
2-6
9
Added NOTE regarding Swagelok
®
rotatable elbow to Conduit Connections section.
2-6
10
Revised Electrical Housing section.
2-7 13, 14
Added Signal Integrity and Wiring Connections sections to Electrical Considerations
section.
2-11
15
Revised Note (4) for Table 2-1.
2-12, 2-13 16, 17
Figures 2-5 and 2-6 updated to provide consistent number of significant figures in
dimensions; Figure 2-6 updated to show external ground screw.
2-14
18, 19
Revised Electrical section.
2-15
19
Updated Figure 2-7 to include Figure 2-7a and Figure 2-7b
2-15
20, 21
Revised Figure 2-9; Added Figures 2-10 and 2-11.
3-2, 5-3
24, 52
Added NOTE regarding transmitter factory calibration.
3-10 33
Added NOTE regarding typical jumper positions to Coarse Zero Select Jumper
Position Selection Procedure section.
3-10
34, 35
Replaced Table 3-1 – Coarse Zero Select with Figure 3-8.
3-12 36
Added Note (1) to Correction for High Static Line Pressure section; Updated High
Static Line Pressure Span Effect on Range Codes 1, 2, and 3 DP Transmitters
section.
3-17 42
Updated High Static Line Pressure Zero Correction for DP Transmitters (All Ranges)
section.
5-5
54
Revised Test Terminal section; Added Figure 5-2.
5-8, 5-11
57, 59
Revised IMPORTANT note.
5-14
62
Revised Electronics Housing Cover Installation section.
5-16
65
Added Screen Plug and Electrical Connector to Table 5-2.
6-3 71
Added NOTE regarding storage of spare electronics assemblies and separate shelf
life statement for spare o-rings to Spare Parts Storage and Shelf Life section.
6-4, 6-6
73, 74
Added External Ground Screw to Transmitter Spare Parts section.
NOTE
The above Revision Status list summarizes the changes made. Please refer to both manuals for
complete comparison details.
NOTE
Revision of the Reference Manual has no impact to form, fit, or function and does not impact
transmitter qualification. Updates were made to provide clarity and improve customer
experience/usage.