6.3 Use Preferences tab
About this task
The Preferences tab, shown in Figure 6-3, allows you to select the preferred
engineering units to display.
Procedure
1. Select the preferred engineering units.
2. If Custom Units are selected, configure the Individual Parameters.
3. Check the box if unit preferences should be retained for future
Engineering Assistant sessions.
Figure 6-3: Preferences Tab
6.4 Select fluid for database liquid/gas
About this task
The Fluid Selection tab shown in Figure 6-4 allows the user to choose the
process fluid.
Quick Start Guide October 2018
20 Rosemount 3051SMV
To Next Page
Loading...
