Emerson SP2404 - User Trip; Status Word; Trip 0 Time: Years.days

Safety
Information
Introduction
Product
information
System
design
Mechanical
installation
Electrical
installation
Getting
started
Optimisation
Parameters
Technical
data
Component
sizing
Diagnostics
152 Unidrive SP Regen Installation Guide
www.controltechniques.com Issue Number: 2
When a value other than zero is written to the user trip parameter the actions described in the following table are performed. The drive immediately
writes the value back to zero.
The bits in this parameter correspond to the status bits in menu 10 as follows.
10.38 User trip
Drive mode Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
111
Range Regen 0 to 255
Default Regen 0
Update rate Background
Value written to
Pr 10.38
Action
1 No action
2 to 30 Trip with same number as value written
31 No action
32 to 99 Trip with same number as value written
100 Drive reset
101 to 199 Trip with same number as value written
200 No action
201 to 204 Trip with same number as value written
205 No action
206 to 209 Trip with same number as value written
210 No action
211 to 219 Trip with same number as value written
220 to 254 No action
255 Clear trip and trip time logs
10.40 Status word
Drive mode Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
111 1
Range Regen 0 to 32,767
Update rate Background
15 14 13 12 11 10 9 8
Not used Pr 10.15 Pr 10.14 Pr 10.13 Pr 10.12 Pr 10.11 Pr 10.10 Pr 10.09
76543210
Pr 10.08 Pr 10.07 Pr 10.06 Pr 10.05 Pr 10.04 Pr 10.03 Pr 10.02 Pr 10.01
10.41 Trip 0 time: years.days
Drive mode Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
31 1 1 11
Range Regen 0.000 to 9.365 Years.Days
Update rate Background
10.42 Trip 0 time: hours.minutes
Drive mode Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
1211111
Range Regen 00.00 to 23.59 Hours.Minutes
Update rate Background