Unidrive M600 Getting Started Guide 23
Issue Number: 2
Safety information Product information
Mechanical
installation
Electrical installation Getting started Basic parameters Running the motor
NV Media Card
Operation
Further information
Figure 3-7 Removal of the size 5 internal EMC filter
Remove the three M5 terminal nuts (1). Lift away the cover (2) to expose the M4 Torx internal EMC
filter removal screw. Finally remove the M4 Torx internal EMC filter removal screw (3) to electrically
disconnect the internal EMC filter.
Figure 3-8 Removal of the size 6 internal EMC filter
To electrically disconnect the Internal EMC filter, remove the screw (1) as highlighted above.
Unidrive M600 Getting Started Guide English Iss1.book Page 23 Friday, April 25, 2014 2:08 PM
To Next Page
Loading...
