24 Unidrive M600 Getting Started Guide
Issue Number: 2
Figure 3-9 Removal of the size 7 and 8 internal EMC filter and line to ground varistors (size 7 shown)
To electrically disconnect the Internal EMC filter, remove the screw as highlighted above (1).
To electrically disconnect the line to ground varistors, remove the screw as highlighted above (2).
The line to ground varistors should only be removed in special circumstances such as ungrounded
supplies with more than one source, for example on ships. Contact the supplier of the drive for more
information.
Unidrive M600 Getting Started Guide English Iss1.book Page 24 Friday, April 25, 2014 2:08 PM
To Next Page
Loading...
