emmeti FEBOS-CRONO User Manual

TABLE OF CONTENTS
GBGB
35
External temp.,
Temp. In and Out Water
and power consumed
from the HP at the alarm start
7. USER SCREENS
7.2 Heat Pump User Screens
On screen 4.1 HEAT PUMP the icon is now visible, as additional
screens are available.
7.2.1 Screen 4.2 - Input/Output Status
The following information is available on this screen:
Input status
Output status
7.2.2 Screen 4.3 - Compressor limitations
On screen 4.3 you can set compressor limitations to:
• Limit the noise of the HP at certain times, for example at night
• Limit the electrical absorption of the HP, to avoid exceeding the
withdrawal threshold from the mains.
Press on the cell to change the value
Daily limitation:
Start time and
max step
of compressor
Maximum withdrawal threshold
from the mains
Graphic representa-
tion
of the daily limita-
tion
7.2.3 Screen 4.4 – Heating water temperature
On screen 4.4 you can set
target temperature of the water being heated:
Press on the cell to change its value
Daily programming
of the screed: (Set 1)
Start time
and temperature
of Target
Temperature
of Target for fan-coils (Set 2)
Graphic representa-
tion of the
daily
programming
of screed

emmeti FEBOS-CRONO Specifications

General

Brand	emmeti
Model	FEBOS-CRONO
Category	Controller
Language	English