- 144 -
Chapter 7. Operation
- Enter a note to change in the program comment input text box in the confirmation part.
- Selecting the
button in the confirmation part executes a comment change and
converts the confirmation part into a command part again.
- In order to cancel the comment change, select the
button. Then its execution is
canceled, and the confirmation part is converted into a command part again.
⑥
button
File area initialization is a function to initialize the entire area stored in an MC program and
a PLC program, and executing this command deletes the entire program, so be careful.
- Select the button. Then a message for confirmation appears, and selecting the
continuing progress button converts the command part into a confirmation part as follows:
- In order to initialize a PLC program area, select the .
- Selecting the
button in the confirmation part executes program area
initialization and converts the confirmation part into a command part again.
- In order to cancel the program area initialization, select the
button.
Then its execution is canceled, and the confirmation part is converted into a
command part again.
⑦ button
The
button reads all the MC program information registered in an MCU again and then
reconstructs the MC program list.
(4) I/O explorer-1, 2, 3
You can monitor contacts such as input(X), output(Y), flag(F), memory(M), timer, counter, etc. and
set the value of each contact forcedly through an I/O explorer.
Moreover, three same windows can
be displayed at maximum.
You can see the I/O explorer window by dividing it into an XY contact area, M contact area, F
contact and TC contact area.
① XY contact
The XY contact view area is a function to monitor and forcedly set the input and output contact,
so it can be displayed by selecting the
tab in the I/O explorer.
Input contact
Output
contact
To Next Page
Loading...