- 87 -
Chapter 4. PLC Program
10) STOP
(1) Definition
This executes an automatic operation execution stop function of an MC program as an
automatic operation execution stop application command of an MC program, and outputs the
completion of execution after completing automatic operation execution stop of an MC
program by being started by a rising edge input.
The automatic operation execution stop completion output is reset when a program is
mandatorily stopped by a restart or reset command through starting of automatic
operation.
(2) Sequence and timing chart
LOAD X0.0
STOP
OUT Y0.0
X0.0
STOP
REQ OUT
X0.0 Y0.0
Y0.0
AUTO STOP AUTO START
RESET
To Next Page
Loading...