- 88 -
Chapter 4. PLC Program
11) RESET
(1) Definition
This executes an automatic operation execution reset and alarm reset function of an MC
program with an automatic operation execution reset and alarm reset application command
of an MC program, and outputs the completion of execution after completing an automatic
operation execution reset and alarm reset function of an MC program by being started by
a rising edge input.
All other PLC motion application commands cannot be executed with the output of this
application command turned ON by maintaining the input of an automatic operation
execution reset and alarm reset application command ON.
(2) Sequence and timing chart
LOAD X0.0
RESET
OUT Y0.0
X0.0
RESET
REQ OUT
X0.0 Y0.0
Y0.0
RESET
To Next Page
Loading...