Enapter Electrolyser - VENT CONNECTION GUIDE (H2 VENT)

VERSION
DOCUMENT TITLE
RELEASE DATE
03
EL – Owner’s Manual
2022-04-29
EL – Owner’s Manual – Rev.04 – April 2022 24
This is a draft manual, technical specifications are subject to change
EL4.0 all pipes connected
After performing the first-time filling (filling the device with the supplied electrolyte solution), the
device will consume water during operation, at a rate of around 400 mL/hr. The refilling is triggered
automatically from the “H
2
O IN” port. This occurs periodically during operation, or directly after ramp
down.