PUTTING IN OR REPLACING THE BATTERIES
Use a soft cloth or tissue to wipe the meter exterior.
If necessary, the soft cloth or tissue might be dipped in a small
amount of alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Store all the meter components in the portable case to
prevent loss.
Caution:
extended period of time.
test strip port.
such as cell phones and microwave ovens.
Bravo™ Meter should be used only with Bravo™ strips.
prevent loss.
CARING FOR YOUR SYSTEM
Removing the meter batteries will not affect your
stored result. However, you may need to reset
your meter settings. See pages 12 ~ 15.
Note
Make sure the meter is turned off.
Push the cover in the direction
of the arrow to open the battery
compartment.
Remove the old batteries one by
one by lifting with the index finger
and pulling with your thumb and
index fingers as shown in the
figure on the right. Insert two new
batteries with the + side facing up
and make sure the batteries are
inserted firmly.
Place the cover on the battery
compartment. Push down until you
hear the tab click into place.
1
2
3
The Bravo™ Meter comes with two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When the icon appears on the display for the first time,
the battery should be replaced as soon as possible.
The test results might not be saved if the battery runs out.
To Next Page
Loading...