Cerabar M PMC51, PMP51, PMP55 XA02712P-A
Endress+Hauser 7
Safety
instructions:
General
• The device is intended to be used in explosive atmospheres as defined
in the scope of IEC 60079-0 or equivalent national standards. If no
potentially explosive atmospheres are present or if additional
protective measures have been taken: The device may be operated
according to the manufacturer's specifications.
• Staff must meet the following conditions for mounting, electrical
installation, commissioning and maintenance of the device:
• Be suitably qualified for their role and the tasks they perform
• Be trained in explosion protection
• Be familiar with national regulations
• Comply with the installation and safety instructions in the Operating
Instructions.
• Install the device according to the manufacturer's instructions and
national regulations.
• Only use the device in media to which the wetted materials have
sufficient durability.
• Avoid electrostatic charging:
• Of plastic surfaces (e.g. enclosure, sensor element, special
varnishing, attached additional plates, ..)
• Of isolated capacities (e.g. isolated metallic plates)
Safety
instructions:
Special conditions
• In the case of process connections made of polymeric material or with
polymeric coatings, avoid electrostatic charging of the plastic
surfaces.
• In the event of additional or alternative special varnishing on the
enclosure or other metal parts:
• Observe the danger of electrostatic charging and discharge.
• Do not rub surfaces with a dry cloth.
To Next Page
Loading...
