2.4 Mounting position
Positioning the housingAfter the Cerabar S has been mounted, the housing can be positioned so that:
•
the terminal connection compartment can be accessed easily,
•
the display can be seen optimally,
•
the cable entry and cover of the Z/S keys are protected from water.
The housing can turned through 270°:
•
to turn the housing undo the screw below the connection compartment,
•
turn the housing,
•
tighten the screw again.
0 - 10 bar
BA187Y20
loosen
tighten
ZS
BA187Y21
Vertical mounting
Cable points
downwards
Figure 2.10
Mounting of the Cerabar S
•
cable points downwards
•
The cover for the Z/S keys is on the side of the
instrument
Cerabar S 2 Installation
Endress+Hauser 15
To Next Page
Loading...
