Endress+Hauser CM14 - Display Icons

CM14 Operation
Endress+Hauser 15
• Open the Configuration menu
• Confirm an entry
• Select a parameter or submenu offered in the menu
Within the Configuration menu:
• Gradually scroll through the parameters / menu items / characters offered
• Change the value of the selected parameter (increase or decrease)
Outside the Configuration menu:
Display enabled and calculated channels, as well as minimum and maximum values, for all the active
channels.
You can always exit menu items / submenus by selecting "x Back" at the end of the menu.
Leave the setup directly without saving the changes by pressing the ‘-’ and ‘+’ keys
simultaneously for longer (> 3 s).
5.3 Icons
5.3.1 Display symbols
Hold function →  16 active.
Max Maximum value/value of the maximum indicator of the channel displayed
Min Minimum value/value of the minimum indicator of the channel displayed
Error, under/over range.
No measured value is displayed.
The device is locked / operator lock; the device setup is locked for changes to parameters; the
display can be changed.
The error and the channel identifier (TAG) are specified in the dot matrix section.
5.3.2 Icons in the editing mode
The following characters can be used to enter user-defined text:
‘0-9’, ‘a-z’, ‘A-Z’, ‘+’, ‘-’, ‘*’, ‘/’, ‘\’, ‘%’, ‘°’, ‘2’, ‘3’, ‘m’, ‘.’, ‘,’, ‘;’, ‘:’, ‘!’, ‘?’, ‘_’, ‘#’, ‘$’, ‘"’, ‘´’, ‘(’, ‘)’,
‘~’
For numerical entries, the numbers ‘0-9’ and the decimal point are available.
Furthermore, the following icons are used in the editing mode:
Symbol for setup
Symbol for expert setup
Symbol for diagnostics
Accept entry.
If this symbol is selected, the entry is applied at the position specified by the user, and you quit editing
mode.