CM14 Safety instructions
Endress+Hauser 5
1.4 Designated use
The transmitter evaluates measured values of an analytical sensor and visualizes them on its
multicolored display. Processes can be monitored and controlled with the unit's outputs and
limit relays. The device is equipped with a wide array of software functions for this purpose.
• The manufacturer does not accept liability for damage caused by improper or non-
designated use. The device may not be converted or modified in any way.
• The device is designed for installation in a panel and must only be operated in an installed
state.
1.5 Technical improvement
The manufacturer reserves the right to adapt technical details to the most up-to-date
technical developments without any special announcement. Please contact your sales center
for information on modifications or updates to the Operating Instructions.
1.6 Return
For a return, e.g. in case of repair, the device must be sent in protective packaging. The
original packaging offers the best protection. Repairs must only be carried out by your
supplier's service organization.
When returning the device for repair, enclose a note with a description of the problem
and the application.
1.7 Notes on safety conventions and icons
1.7.1 Warnings
L
DANGER
Causes (/consequences)
Consequences of non-compliance (if applicable)
‣
Corrective action
‣
This symbol alerts you to a dangerous situation. Failure to avoid the situation will result in
a fatal or serious injury.
L
WARNING
Causes (/consequences)
Consequences of non-compliance (if applicable)
‣
Corrective action
‣
This symbol alerts you to a dangerous situation. Failure to avoid the situation can result in
a fatal or serious injury.
L
CAUTION
Causes (/consequences)
Consequences of non-compliance (if applicable)
‣
Corrective action
‣
This symbol alerts you to a dangerous situation. Failure to avoid this situation can result in
minor or more serious injuries.
To Next Page
Loading...
