Endress+Hauser Deltapilot M FMB51 - Page 28

Operation Deltapilot M 4...20 mA HART
28 Endress+Hauser
For an overview of the entire operating menu: see operating instructions.
Direct access to parameters
The parameters can only be accessed directly via the "Expert" user role.
6.3.3 Operation with a device display (optional)
A 4-line liquid crystal display (LCD) is used for display and operation. The local display shows
measured values, dialog texts, fault messages and notice messages.
For easy operation the display can be taken out of the housing (see figure steps 1 to 3). It is
connected to the device through a 90 mm (3.54 in) cable.
The display of the device can be turned in 90° stages (see figure steps 4 to 6).
Depending on the orientation of the device, this makes it easy to operate the device and read the
measured values.
A0028500
Parameter name Description
Direct access (119)
Entry
Menu path:
Expert  Direct access
Enter the direct access code to go directly to a parameter.
Options:
• Enter the desired parameter code.
Factory setting:
0
Note:
For direct access, it is not necessary to enter leading zeros.
1.
2.
3.
4.
5.
6.