Endress+Hauser iTEMP HART TMT182 - Supported HART Commands

6 Commissioning TMT182
24 Endress+Hauser
6.2.6 Supported HART
®
commands
No. Description Access
Universal Commands
00 Read unique identifier r
01 Read primary variable r
02 Read p.v. current and percent of range r
03 Read dynamic variables and p.v. current r
06 Write polling address w
11 Read unique identifier associated with tag r
12 Read message r
13 Read tag, descriptor, date r
14 Read primary variable sensor information r
15 Read primary variable output information r
16 Read final assembly number r
17 Write message w
18 Write tag, descriptor, date w
19 Write final assembly number w
Common practice
34 Write primary variable damping value w
35 Write primary variable range values w
38 Reset configuration changed flag w
40 Enter/Exit fixed primary varaible current mode w
42 Perform master reset w
44 Write primary variable units w
48 Read additional transmitter status r
59 Write number of response preambles w
108 Write burst mode command number w
109 Burst mode control w
E+H specific
144 Read matrix parameter r
145 Write matrix parameter w
148 Upload r
149 Download w