To Next PageTo Next PageWhat to do if my Endress+Hauser iTEMP TMT82 is not responding?
If your Endress+Hauser Transmitter is not responding, it could be due to: * The supply voltage not matching the nameplate specifications. Apply the correct voltage. * The connecting cables not properly contacting the terminals. Check the cable connections and correct them if necessary.
How to fix HART communication not working on Endress+Hauser iTEMP TMT82 Transmitter?
If HART communication is not working on your Endress+Hauser Transmitter, consider the following: * A communication resistor might be missing or incorrectly installed. Install the communication resistor (250 W) correctly. * The Commubox might not be properly connected. Connect the Commubox correctly. * The Commubox might not be set to "HART". Set the Commubox selector switch to "HART."
What causes failure current on Endress+Hauser iTEMP TMT82?
A failure current on your Endress+Hauser Transmitter can be caused by: * A faulty sensor. Check the sensor. * The sensor connected incorrectly. Connect the connecting cables correctly (terminal diagram). * Incorrect programming. Set the correct sensor type in the Sensor type device function.
What could cause an incorrect measured value on Endress+Hauser iTEMP TMT82?
An incorrect measured value on your Endress+Hauser Transmitter can occur if: * The sensor orientation is incorrect. Install the sensor correctly. * Heat is conducted by the sensor. Observe the face-to-face length of the sensor. * The device programming is incorrect (number of wires). Change the Connection type device function.
Why is the output current less than 3.6 mA on my Endress+Hauser iTEMP TMT82?
If the output current is less than 3.6 mA on your Endress+Hauser Transmitter, it may be because: * The signal line is not wired correctly. Check the wiring. * The electronics unit is defective. Replace the device.
General| Brand | Endress+Hauser |
|---|---|
| Model | iTEMP TMT82 |
| Category | Transmitter |
| Language | English |
