Endress+Hauser Levelflex M FMP45 - 7 Function Group Extended Calibr. (05); Function Selection (050); Function Check Distance (051)

Levelflex M 7 Function group "extended calibr." (05)
Endress+Hauser 41
7 Function group "extended calibr." (05)
7.1 Function "selection" (050)
Select the function of the extended calibration.
Selection:
• common (e.g. "Level correction", "Output damping", etc.)
•mapping
• delete mapping
7.2 Function "check distance" (051)
This function triggers the mapping of interference echoes. To do so, the measured distance must be
compared with the actual distance to the product surface. The following options are available for
selection:
Selection:
•distance = ok
• dist. too small
• dist. too big
• dist. unknown
•manual
•probe free
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
+
+
distance too small distance = ok